4 Overall dimensions and technical information are provided solely for informative purposes and may be modified without notice. Series 1500 Short stroke compact cylinders General Profiled tube has three "T" slots on the three sides hosting sensors 1500._, RS._, HS._. without adaptors and with adaptor code 1380.01F codes 1580._, MRS._, MHS._. A complete range of clampsmakes themeasy to install under any conditions. It is interesting to note that as these cylinders (fromØ 32 to Ø 100) have anchoring holes with the same lead and thread as those of series 1320 ISO6431, they accept all mountings except for the intermediate trunnion. Standard strokes Type 1501, 1504, 1511, 1514, 1515, 1516, 1517 and 1518: for all bores from5 to 50mmevery 5mm. Type 1502, 1503, 1512 and 1513: for all bores from5 to 10mm. Type with non-rotating device: Ø 20 andØ 25 from5 to 40mmevery 5mm. Ø 32 andØ 40 from5 to 50mmevery 5mm. Ø 50 andØ 63 from5 to 60mmevery 5mm. Ø 80 andØ 100 from5 to 80mmevery 5mm. Fluid Max. pressure Working temperature Body Rod Piston Rod bushing End plate Seals anodised aluminium C43 chromed steel (stainless steel for magnetic cylinder Ø20 and Ø25) aluminium anodised aluminium anodised aluminium Standard: NBR Oil resistant rubber, PUR Piston rod seals (HNBR or FPM seals available upon request) Construction characteristics filtered and preferably lubricated air 10 bar -5°C - +70°C with standard seals magnetic or non magnetic piston -5°C - +80°C with FPM seals magnetic piston -5°C - +80°C with HNBR seals magnetic piston -5°C - +120°C with HNBR seals non magnetic piston -5°C - +150°C with FPM seals non magnetic piston Technical characteristics Please follow the suggestions below to ensure a long life for these cylinders: •use clean and lubricated air •correct alignment during assembly with regard to the applied load so as to avoid radial components or bending the rod. •avoid high speeds together with long strokes and heavy loads: this would produce kinetic energy which the cylinder cannot absorb, especially if used as a limit stop (in this case use mechanical stop device) •evaluate the environmental characteristics of cylinder used (high temperature, hard atmosphere, dust, humidity etc.) Please note: air must be dried for applications with lower temperature. Use hydraulic oils H class (ISO VG32) for correct continued lubrication. Our Technical Department will be glad to help. 4.121