Overall dimensions and technical information are provided solely for informative purposes and may be modified without notice Cylinders according to standard ISO 15552 3 | 43 Series 1348 - 1349 - 1350, Non rotating cylinders 3 Pneumatic actuation Technical characteristics End caps Rod Barrel Cushion bushings Piston Piston seals Cushioning adjustement screw UNI 5079 aluminium alloy casting painted black by cataphoresis C43 chromed steel Ra = 0.2 UNI 9006/1 aluminium alloy square section, hardened 30 micron oxidate 2011 UNI 9002/5 hardened alloy aluminium polyacetal resin, self-lubricated and anti-wear, with plastoferrite rings in magnetic version NBR oil-resistant rubber, PUR Piston rod and cushion seals brass Fluid Pressure Operating temperature Filtered air. No lubrication needed, if applied it shall be continuous. 10 bar -5°C - +70°C Series 1348-1349-1350, Non rotating cylinders Construction characteristics Please follow the suggestions below to ensure a long life for these cylinders: •use clean and lubricated air •correct alignment during assembly with regard to the applied load so as to avoid radial components or bending the rod. •avoid high speeds together with long strokes and heavy loads: this would produce kinetic energy which the cylinder cannot absorb, especially if used as a limit stop (in this case use mechanical stop device) •evaluate the environmental characteristics of cylinder used (high temperature, hard atmosphere, dust, humidity etc.) Please note: air must be dried for applications with lower temperature. Use hydraulic oils H class (ISO VG32) for correct continued lubrication. Our Technical Department will be glad to help. Standard strokes (for all diameters) from 0 to 150, every 25 mm Bore Other stroke for these following bores: Ø 32 80 mm Ø 40 80 - 160 mm Ø 50 80 - 160 - 200 - 250 mm Ø 63 80 - 160 - 200 - 300 - 320 mm 32 40 50 63 8.31 12.41 18.41 29.67 0.5 0.8 1.1 1.5 12' 12' 12' 12' 22 27 27 32 Usable surface (square profile) cm² Grade precision (rest rod, without load) anti-rotation Max couple on the rod (max torque) Nm Cushion length mm. Stroke Tolerance (ISO 15552) Bore Stroke Tolerance 32 - 40 - 50 - 63 up to 500 +2 0 On request are available strokes up to 1000 mm
RkJQdWJsaXNoZXIy NzYzOTY1